Owners of country or country houses are often asked about water supply, the solution of which is possible in two ways: drilling a well or building a well. If in the first case you need to resort to the help of organizations, then the well can be built with your own hands. During the construction of the well, you need to pay attention to: the profitability of digging the well, first of all, you need to find out the depth of digging well. The aquifer should be at a depth of up to 15 meters, only in this case it is recommended to dig. It is also necessary to calculate possible costs and compare them with the drilling of the well to the same depth. The well for the well should be located only where there are no pollution in the soil. The location can be absolutely any. If you want to determine the depth for digging, you must forget about all kinds of shamanistic rituals with metal frames. But there is one proven way: you can ask the neighbors with the depth of the well, with a probability of almost 100%, and you will have the same. However, it is possible to accurately measure the depth of the aquifer of the aquifer only when drilling a reconnaissance well. Digging technique for initial digging is a team of two people. One of them is below and picks up the soil in a bucket with a shovel, and the second is located above and lifts the stones and soil, then dumping everything into a heap. To rise above the well, it is necessary to install a tripod to which will be attached
DIY well
winch. The third person will be needed later to put well rings. They should be lowered using a steel cable. As you dig, the well rings under the influence of its own weight will go down. When water begins to flow, it becomes inconvenient to dig, and you can use a suspension platform on which it is convenient to dig sit. The materials used are most often made with a diameter of about 1 meter and about 0.8 meters high. Large rings are rarely used. You can use stones and bricks, which is extremely uneconomical and inconvenient. With deep groundwater occurrence, you can use a metal or plastic pipe. In this case, the water will be lifted by the pump, it can additionally be installed on the bottom of the well filter.