It must be immediately reminded that the entire list of requirements that are presented to the construction of such structures as chimneys can be formed simultaneously on the basis of special requirements for the construction of furnaces and fireplaces, and on the basis of the requirements for roofers. Summarizing the two lists and making them an analysis based on the stock of some technical knowledge that has appeared, we can offer several useful tips. One of them: this is to buy an entrance hall.
The first thing to pay attention to is the parameters, as well as the very location of the chimney going to the roof. According to the accepted standards, the height of the chimney pipe should not be lower than the height of the ridge when it is 1.5-3 meters from it from it. Experts propose to have a pipe almost near the skate. Moreover, we do this intuitively, recalling the fact that in old buildings, the stove pipe was usually located on the skate itself. It must be recalled that such a standard is often subsequently turned out to be a real problem for roofers, who argue that the optimality of such a solution is erroneous.
The device of chimneys is often a determining factor in the functionality of furnaces and fireplaces, as well as the quality and functionality of the roof of the building. The characteristics of the smoking structure directly affect the choice of roofing material, as well as the technology of roofing. Not a simple task for roofers and stovers is the output of the chimney directly through the roof. Although the baggage of experience and knowledge of specialists allows you to solve this problem in the best way for functionality, labor intensity and cost without any efforts.
In the case of the arrangement of the chimney, construction and state standards are not limiters of the choice of material and technology. This function by inertia is taken by experts and specialists. Following their advice, it is necessary to pay attention to engineering structures manufactured by eminent operators of the construction market. Ferrum chimney systems, for example, are often recommended by the same specialists. The quality of ferrums does not cause any doubt, especially the proposed assortment does not leave indifferent many customers of work. Another volcano chimneys are no less popular in customers, possessing their own peculiarity, which is in the targeted use of stainless steel, which has deserved special honor over time and in other sectors. A good option is Lokki chimneys (Lockes), which are made of steel covered with enamel. Such pipes are ready for the most unfavorable weather conditions, as well as internal thermal loads.