Features of the operation of garage gates: what you need to know

Features of the operation of garage gates: what you need to know

Almost all owners of suburban areas with their own personal car have a garage. The operation of this building has some features that need to pay close attention to.

If dust flies under the garage gates or the leaves on them must be hanged by the strip of the seal. As such a strip, thick rubber is perfect that can be cut from a car chamber of a truck. You will need a strip of which will be approximately twice as much as the gate gap under the gate. To fix the rubber, you need a metal strip and a certain number of screws. As a strip, you can use the usual galvanized tin. Everything is simple here, at first rubber is applied to the gate, and then it is pressed by a metal strip, after which self -cutting self -cuts are screwed up.

Garage gates, as you know, can be closed on both sides. If there is an additional entrance, then they are usually closed from the inside, but if it is not, then the gates are closed with a hinged lock. So if the garage is built on its own site and if its gate goes outside, then they can be closed in a few simple ways. The first method is to use simple metallic rods. After the repair, many want a vacation anchor gap for this is perfect.

You need to close as you know two gate. Typically, the gates are welded from the metal corners, the lower corners, and to be more accurate, one of their planes in this case is always parallel to the earth than you can use. First you need to drill one hole in the lower corners near each edge then close the gate and drill through these holes of the hole in the clouding corner. Further, in order to close the gate, you just need to insert the pins into the holes. Of course, the second method is the use of a hinged lock from the inside. To do this, you will need to weld two loops and the case in the hat. Both in the first and in the second case, opening the gate from the street will be simply impossible.