In any house or apartment, in order for wall decoration to be beautiful and lasted for a long time, it is necessary to perform high -quality plastering the surface of the walls. The main task of this process is to achieve the strength of the adhesion of the solution with the wall surface. First of all, from prepared surfaces, it is necessary to remove pollution, dust and make the structure of the wall rough.
Plastering is carried out in three stages. At the first stage, called spray, the solution is applied to the surface of the walls with a large application of strength and sharpness, so that the solution is better “clinged” with the wall. After a while, it will be necessary to make a grout, with a thickness of no more than two to three centimeters.
The drying of the plaster should occur at natural temperature, without additional heating, which can cause cracking and falling of the plaster layer. The amount of plaster layers applied depends on the material and the structure of the surface on which it is applied.
Plaster solutions are lime, gypsum, magnesian and cement-sand. Lime solution, due to its environmental friendliness and convenience of working with it, is often used for internal finishing work. For external and internal work, the cement-sand solution is most often used, since it, in its qualities, is not inferior to gypsum and lime solutions, but much cheaper. Gypsum solutions for plastering are mainly used for internal work in order to get a smooth white coating. Plaster from gypsum road is very unstable to the effects of moisture and very low.