During construction and repair work, the owners of houses often have to think about how to arrange the ceilings. It is best to perform a ceiling made of modern material – drywall. To do this, first of all, it is necessary to determine the distance between suspended ceilings. Based on this, it is necessary to make not only markings, but also the installation of guide profiles. After the guide profiles are already installed, it is necessary to note the installation sites of the main profiles and the so -called suspensions. To put the main profiles in one plane, to the perimeter profiles, it is necessary to screw the screws. On these screws, it is necessary to pull the threads from Kapron. The threads should be almost close to the profile, and also be located along the entire length of the room at a distance of about a meter from each other.
When installing a ceiling made of material such as drywall, moisture -resistant in small rooms – such as a corridor and bathroom, profiles are exhibited by means of special levels. The threads should not touch the profiles, because in this case it will not be possible to achieve an even ceiling. The threads should not reach one millimeter to the exhibited profiles. This distance for all profiles should be the same. With the help of dowels, suspensions must be attached to concrete ceilings.
If the ceiling is made of wood, then the suspensions to it must be attached on a tree self -tapping screws. Basic profiles are aligned by the adjustment of suspensions in one plane. Then it is necessary to attach the transverse elements of the frame to them, t. e. jumpers made of short profiles. Thus, it turns out a mesh from a frame of 40 by 40 centimeters.