Milling boards are equipped on different sides by grooves and crests. They are made in factories and can have different sizes. In addition to the boards at such plants, smaller bars are produced (35×28 mm). Each board or a bar with below is equipped with a recess that allows you to tightly fit to the basis on which they will be laid – lags or lags. This also allows you to maintain air circulation when installing insulated floors.
Dear friends, if you have no time to clean the house. Then we advise you to use the service – the professional cleaning that you can order by passing the link we specified. Also, there you will find a lot of useful and interesting information about professional cleaning and learn its cost.
Triangular vents between boards and beams high and 20 mm wide are considered the most reliable. A small bevel, made on the groove made on the front side will allow the boards to fit denser. Starting to lay boards, a small indent should be made from the wall. In each beam or lag, you need to score nails. It is necessary to drive a width into each milling board, which is more than 90 mm in two nails.
In order to remove the session not to damage the strip knife with a hydroeine, hats from nails are three millimeters. In order to subsequently do not penetrate into the obtained recesses, their water should be thrust. The second one is applied to the first laid board and, using the wedges and brackets, you need to drive out nails. The final boards are laid, like the previous.